Other Name: Lamp Assembly, Rear, Right-Hand; Back Up Light Assembly, Rear Right; Tail Light Assembly; Other Lamp; Lamp Assembly, Rear, Passenger Side; Back Up Light
Q: How to remove and reinstall the tail light on the left-hand side on Scion xA?
A: The first step to remove the LH side tail lamp requires disconnecting the cable from the negative battery terminal and waiting for at least ninety seconds to avoid activating the Air Bag and seat belt pretensioners. The first step requires you to remove the rear combination light service cover LH before taking out the rear combination light assembly LH through connector disconnection and removal of two nuts. The installation process starts with rear combination light assembly LH attachment using 2 nuts while reconnecting the connector. After that reinstall the rear combination light service cover LH and connect the cable to the negative battery terminal. The procedure concludes with initialization since some systems need battery cable initialization during polarity changes.
Q: How to remove the rear Tail Light assembly on Scion xD?
A: The first step to remove the rear combination light assembly includes use of a moulding remover that detaches both 4 claws and 3 guides to enable removal of the rear combination light service cover. Begin by disconnecting the connector prior to taking out the 2 mounting nuts. Reach inside the vehicle to pinch the clip with your fingers while removing the clip from the vehicle and extracting the pin to remove the rear combination light in its entirety. Technicians must follow this procedure for treating the RH and LH sides of the vehicle yet the instructions apply specifically to the LH side.
Q: How to remove and install the rear Tail Light assembly on the LH side on Scion xB?
A: The first step to remove the rear combination light assembly from the LH side is disconnecting the negative cable from the battery terminal for at least 90 seconds to avoid activating the Air Bag and seat belt pretensioners. Begin by uninstalling the rear combination light service cover LH before proceeding to disconnect the rear combination light assembly LH connector then eliminate its two nuts. Place the rear combination light assembly LH in position by attaching its 2 nuts and connecting the connector. After replacing the rear combination light service cover on the LH side complete the repair by connecting the cable to the negative battery terminal.