Toyota 81551-52690
Tail Lamp Assembly, Passenger Side

The first step to remove the rear combination light assembly includes use of a moulding remover that detaches both 4 claws and 3 guides to enable removal of the rear combination light service cover. Begin by disconnecting the connector prior to taking out the 2 mounting nuts. Reach inside the vehicle to pinch the clip with your fingers while removing the clip from the vehicle and extracting the pin to remove the rear combination light in its entirety. Technicians must follow this procedure for treating the RH and LH sides of the vehicle yet the instructions apply specifically to the LH side.

The initial step for disassembling the rear combination light assembly requires you to eliminate the rear combination light gasket by detaching adhered parts from the body then install a new gasket to stop water entry. The next step requires users to twist the rear combination light socket and bulb together in the indicated direction until removal occurs. Then users should take out both the rear combination light bulb and socket from their current position. People must turn the rear turn signal light socket and bulb in the indicated direction to detach them from the system before removing the rear turn signal light bulb from the socket. To remove the back up light bulb and socket the user must turn them according to the indicated direction.

Yes, this procedure is applicable to both the RH and LH sides, with the steps outlined specifically for the LH side.

Remove the rear combination light gasket, ensuring to detach it if it adheres to the body, and replace it with a new one to prevent water ingress.

Install the back up light bulb into the light socket and turn the socket and bulb in the direction indicated by the arrow to secure them.