OEM 2009 Toyota Tacoma Antenna Cable

2009 Toyota Tacoma Parts Questions & Experts Answers

• Q: How to install the Radio Antenna Cable and associated components on 2009 Toyota Tacoma?

  A: The installation process for Radio Antenna Cord requires engagement of 4 claws followed by the Radio antenna cord sub-assembly installation. After which install the instrument panel sub-assembly together with the instrument panel passenger Air Bag assembly while making sure the passenger Air Bag connector is properly connected. The installation requires fitting of the instrument side panel RH followed by installing the instrument lower cover sub-assembly and the lower instrument panel LH. After which install the instrument panel lower finish panel sub-assembly RH then follow with the glove compartment door assembly and the center instrument cluster finish panel sub-assembly. Installation of the combination meter assembly should proceed with the instrument cluster finish panel sub-assembly and the No. 1 lower instrument panel finish panel. You should put in the hood lock control lever sub-assembly followed by the installation of the radio receiver assembly and the air conditioning control assembly. The front console box receives installation based on transmission type and seat setup which supports manual and automatic transmissions on bench and separate seat systems. The front production of the instrument panel cup holder tray fits automatic transmission on separate seats while the rear console box assembly mounts to separate seats and the console upper rear panel sub-assembly serves both manual transmission and automatic transmission on separate seats. Put in the instrument panel hole cover if brake parking lever is used or add the instrument panel under tray when brake parking uses pedals. First the front pillar garnish RH and LH should be installed and then the front door opening trim Weather Strip RH and LH follows. Place the front door scuff plate followed by front floor footrest and cowl side trim boards both on the right-hand and left-hand sides. Attach the cable to the negative battery terminal while tightening it to 3.9 Nm (40 kgf-cm, 35 in-lbf).