How to remove and replace the starter motor on 2009 Toyota Sequoia?

Question

Accepted Answer

The first step to replace or remove the starter motor of a 2UZ-FE engine includes disconnecting the negative battery cable before waiting 90 seconds then re-connecting because some systems need post-reconnection initialization. The service and repair procedures should be followed to remove the Bank 1 air pump assembly. Start by loosening the clip on the No. 2 air hose and remove the three bolts before taking off the air tube with its gasket. First uninstall the rear water by-pass joint from the cylinder head through nut removal and gasket handling of all four elements together with both gaskets. The starter assembly removal begins by taking down two cylinder block securing bolts before detaching from the block followed by starter wire protector bolt removal. First disconnect the starter assembly wire by removing its bolt followed by disconnecting the ground wire then separating the starter assembly connector before removing its nut and finally removing the starter assembly.

OEM 2009 Toyota Sequoia Starter Motor

2 Starter motors found

2009 Toyota Sequoia Starter Assembly

2009 Toyota Sequoia Starter

2009 Toyota Sequoia Starter Motor

2009 Toyota Sequoia Parts Questions & Experts Answers

Related 2009 Toyota Sequoia Parts

Alternate Year Models