Other Name: Belt Assembly, Rear Seat; Seat Belt Lap and Shoulder Belt, Rear Right; Belt & Retractor; Belt Assembly, Rear Seat, Outer Passenger Side
Manufacturer Note: THIRD SEAT-WITH(2PERSONS),DK.GRAY,TRIM4#
Position: Outer Passenger Side
Part Name Code: 73560
Item Weight: 2.90 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 73560-42010-E3
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2009 Toyota RAV4 Submodels:
Base, Limited, Sport | 4 Cyl 2.5 L GAS, 6 Cyl 3.5 L GAS
| Page 1 of 3 |Next >
1-20 of 43 Results
2009 Toyota RAV4 Seat Belt
Looking for affordable OEM 2009 Toyota RAV4 Seat Belt? Explore our comprehensive catalogue of genuine 2009 Toyota RAV4 Seat Belt. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2009 Toyota RAV4 Seat Belt Parts Q&A
Q: How to install the front Seat Belt assembly on the LH side on 2009 Toyota RAV4?
A: The installation process for the LH front seat outer belt assembly starts with the front shoulder belt anchor adjuster assembly installation through aligning the adjuster positioning hole with the claw followed by bolt retention with 42 Nm (428 kgf-cm, 31 ft-lbf) torque. The installation process for the front shoulder belt anchor plate sub-assembly LH includes fitting it between the claws of the garnish before tightening it into place. The front seat outer belt assembly LH can be installed by fitting the 2 claws to the seat belt positioning holes and securing the retractor with a bolt which should be torqued to 8.5 Nm (87 kgf-cm, 75 in-lbf). The pretensioner connector should be attached to the bolt that secures the outer belt to the shoulder anchor with 42 Nm (428 kgf-cm, 31 ft-lbf) torque. Add the outer belt anchor through the center pillar garnish LH before securing it with two screws while attaching the clip. In the installation process of the center pillar garnish lower LH, attach two claws and two clips to the floor anchor and fix it using a bolt tightened to 42 Nm (428 kgf-cm, 31 ft-lbf) while also attaching the lap belt outer anchor cover. Include the rear door opening trim Weather Strip LH alongside the rear door scuff plate LH and front door scuff plate LH and finally the front door opening trim Weather Strip LH in the installation process. Put the negative cable wire into the last terminal of the battery.