OEM 2009 Toyota Land Cruiser Yaw Sensor

2009 Toyota Land Cruiser Parts Questions & Experts Answers

• Q: How to install the Yaw Sensor and complete the associated assembly tasks on 2009 Toyota Land Cruiser?

  A: Begin the installation of the Yaw Rate Sensor by connecting its sensor connector to the bracket while attaching the clamp to the bracket hole and then tightening it securely. You should install the yaw rate sensor using two bolts with 15 Nm (148 kgf-cm, 11 ft-lbf) torque setting. Proper orientation of the sensor matters during installation at the same time replacement must happen immediately after drops and any impacts should be avoided altogether throughout the installation process. Following the sensor installation, proceed to install the rear console box sub-assembly (w/o Cool Box), the cooling box assembly (w/ Cool Box), the rear console end panel sub-assembly, the No. 1 cooler cover (w/ Cool Box), the upper console panel sub-assembly, the console cup holder box sub-assembly, the rear upper console panel sub-assembly, the lower center instrument cluster finish panel sub-assembly, the shift lever knob sub-assembly, the lower instrument panel pad sub-assembly RH, the No. 1 instrument panel finish panel cushion, the lower instrument panel pad sub-assembly LH, the No. 2 instrument panel finish panel cushion, and the front seat assembly LH (w/ Cool Box). The next steps include charging the refrigerant with Cool Box while performing the connection of the cable to the negative battery terminal along with engine removal using Cool Box for checking refrigerant gas leaks through Cool Box operation. Conduct the yaw rate sensor zero point calibration procedure while also checking the sensor signal output.