OEM 2009 Toyota Land Cruiser Water Pump

2009 Toyota Land Cruiser Water Pump Parts Q&A

• Q: How to install the water pump assembly on 2009 Toyota Land Cruiser?

  A: Begin water pump assembly installation by using a new gasket to fasten the pump with 8 bolts through the order of tightening bolt A to 47 Nm (479 kgf-cm, 35 ft-lbf), then bolt B to 23 Nm (235 kgf-cm, 17 ft-lbf), and finally bolt C to 20 Nm (204 kgf-cm, 15 ft-lbf). Next, install the water pump pulley temporarily using 4 bolts but secure it with Special Service Tool: 09960-10010 09962-01000 before tightening the bolts to 21 Nm (214 kgf-cm, 15 ft-lbf). Place a new gasket on the water pump before threading three bolts to secure the water inlet housing and attaching the No. 3 water by-pass hose while torquing it to 21 Nm (214 kgf-cm, 15 ft-lbf). Install the air tube bracket bolt to 10 Nm (102 kgf-cm, 7 ft-lbf) and then connect the No. 5 water by-pass hose after which attach the air pump connector clamp holder, wire harness clamp, air pump connector, and No. 2 and No. 3 air hoses. The installation of the No. 2 water by-pass pipe sub-assembly with oil cooler requires attaching the water by-pass pipe to its hose followed by torquing three bolts to 10 Nm (102 kgf-cm, 7 ft-lbf) while also connecting the No. 6 water by-pass hose. The installation sequence includes putting in the No. 1 water by-pass hose then the fan shroud after which the No. 1 and No. 2 radiator hoses together with the air cleaner assembly and its air cleaner hose assembly. Engine coolant should be added while the technician checks for any coolant leakage. The last assembly operations involve installing the V-bank cover sub-assembly followed by the No. 1 engine under cover sub-assembly and then completing with both left and right front fender splash shield sub-assemblies.