OEM 2008 Toyota Solara Clock Spring

2008 Toyota Solara Parts Questions & Experts Answers

• Q: How to install the Clock Spring with and without VSC on 2008 Toyota Solara?

  A: The clock spring installation requires engagement of the 6 claws and 2 pins to the steering angle sensor but only when the front wheels face forward and the turn signal switch rests in neutral so the pin stays safe from damage. The installation procedure for a clock spring without VSC requires an initial check to engage all 3 claws except for lock pin removal when substituting with a new piece for the steering wheel assembly. Join the connectors to the clock spring without harming the Air Bag wire harness during installation. The installation moves to putting on steering column cover and lower steering column cover by using 2 screws. Adjust the clock spring by disconnecting the battery negative cable while switching off the ignition before waiting for at least 90 seconds before commencing work. Begin rotating the clock spring in the counterclockwise direction until it becomes firm, then proceed with clockwise rotation about 2.5 times while taking care to handle only the clock spring and not the Air Bag wire harness. The installation process requires installing the steering wheel assembly before checking the steering wheel center alignment and adding the steering pad along with both lower steering wheel covers. After reconnecting the negative battery cable users must initialize the system because system operation demands this step following cable attachment. The inspection should conclude with checks on the steering pad function and the SRS warning light operation.