OEM 2008 Toyota Matrix Clock Spring

2008 Toyota Matrix Clock Spring Parts Q&A

• Q: How to install and adjust the Clock Spring on 2008 Toyota Matrix?

  A: The front wheel alignment and neutral position of the turn signal switch ensure the pin does not snap during clock spring installation. Attach the clock spring by using the 3 claws while you should remove the lock pin when changing to a new cable for steering wheel installation. When attaching the connectors to the clock spring users need to maintain caution against damaging the Air Bag wire harness during Air Bag connector handling before covering the steering column with the upper component. Users should avoid scratching or cracking the connector or disturbing the clock spring. The installation of the steering column lower cover requires three screws for attachment. The procedure to adjust the clock spring requires an off position of the ignition switch and disconnected negative (-) battery terminal and a waiting period of at least ninety seconds. Slowly rotate the clock spring counterclockwise until firm and proceed to rotate it clockwise 2.5 times while avoiding contact with the Air Bag wire harness. From the center the clock spring will rotate by 2.5 turns to both directions. You should first install the steering wheel assembly before you put on the steering pad then complete the connection to the negative battery terminal. A thorough inspection should be done for the steering pad followed by initialization steps because some systems need these procedures during negative battery terminal cable removal. Perform a full test of the SRS warning light to check its operations.