OEM 2008 Toyota FJ Cruiser Window Motor

2008 Toyota FJ Cruiser Window Motor Parts Q&A

• Q: How to install the Window Motor assembly on 2008 Toyota FJ Cruiser?

  A: First apply MP grease on the moving areas of the regulator motor then tighten the power window regulator motor assembly with 3 "Torx" socket T25 wrench screws to a torque specification of 5.4 Nm (55 kgf-cm, 48 in-lbf). Secure the power window regulator motor to its place with 3 screws using a "Torx" socket wrench T25 while setting the torque at 5.4 Nm. This measurement also includes 55 kgf-cm or 48 in-lbf torsional force. The sequence of installation begins with the front door window regulator sub-assembly followed by front door glass sub-assembly and front door window frame rear lower installation and then front door lower frame bracket garnish installment. Place the front door frame sub-assembly front lower followed by the front door glass run and then the front door Weather Strip. The installation sequence includes the front door check assembly as well as the front door inside panel plate and the front door service hole cover. The front No. 1 speaker and front door glass outer Weather Strip assembly together with the outer rear view mirror should be installed after all previous components. The last sequence involves installing the front No. 2 door service hole cover followed by the front door trim board sub-assembly and front armrest base upper panel. Complete the procedure by connecting the cable to the negative battery terminal with 3.9 Nm torque (40 kgf-cm and 35 in-lbf).