Other Name: Arm Sub-Assembly, Suspension; Suspension Control Arm, Front Left; Control Arm Assembly; Lower Control Arm; Arm Sub-Assembly, Front Suspension, Lower Driver Side; Suspension Control Arm
Position: Lower Driver Side
Replaces: 48069-58010, 48069-28120
Part Name Code: 48069
Item Weight: 10.60 Pounds
Item Dimensions: 2.9 x 2.9 x 2.8 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 48069-06100
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Arm Sub-Assembly, Suspension; Suspension Control Arm, Front Right; Control Arm Assembly; Lower Control Arm; Arm Sub-Assembly, Front Suspension, Lower Passenger Side; Suspension Control Arm
Position: Passenger Side
Replaces: 48068-28120, 48068-58010
Part Name Code: 48068
Item Weight: 7.80 Pounds
Item Dimensions: 18.2 x 2.8 x 15.4 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 48068-06100
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Arm Assembly, Rear Suspension; Suspension Control Arm; Rear Lateral Arm; Arm
Position: Rear Passenger Side
Replaces: 48730-07030, 48730-07050
Item Weight: 1.80 Pounds
Item Dimensions: 9.2 x 1.9 x 1.9 inches
Condition: New
SKU: 48730-33150
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2008 Toyota Avalon Submodels:
Base, Limited, Touring, XL, XLS | 6 Cyl 3.5 L GAS
2008 Toyota Avalon Control Arm
Looking for affordable OEM 2008 Toyota Avalon Control Arm? Explore our comprehensive catalogue of genuine 2008 Toyota Avalon Control Arm. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2008 Toyota Avalon Control Arm Parts Q&A
Q: How to remove the rear Control Arm on 2008 Toyota Avalon?
A: The removal of the rear suspension arm begins with taking off the rear wheel. You must disconnect the assembly center which handles the exhaust pipe. Proceed with removing the rear stabilizer bar after following these steps. Frame the rear strut rod before disconnection. Proceed with removing the nut on the height control sensor sub-assembly rear RH (with discharge head light) located on the RH side of the vehicle. Then separate this component. Tear the rear No. 2 suspension arm LH by removing its bolt, nut and outer piece from the rear axle carrier where the nut must not turn. The steps should also be conducted for the rear of the vehicle. This procedure requires disassembling the rear No. 1 suspension arm LH by removing its bolt along with nut and the outer side section of the rear suspension arm No. 1 from the rear axle carrier yet maintaining the nut position stationary. Repeat this for the RH side. First secure the rear suspension member with a jack then unscrew all 4 rear suspension nuts, both 2 bolts and the 4 retainers on the member and lower down the suspension. To complete the procedure remove the bolt as well as rear suspension arm No. 1.