OEM 2008 Scion xD Axle Shaft

2008 Scion xD Axle Shaft Parts Questions & Experts Answers

• Q: How to remove the axle shaft assembly on 2008 Scion xD?

  A: The first step to disassemble the front drive shaft assembly requires you to remove the engine under cover then drain automatic transaxle fluid or manual transaxle oil according to the transmission type. Begin the front drive shaft removal process by taking out the front wheel and front axle hub nut through the use of Special Service Tool: 09930-00010 and carefully tapping the staked part with a hammer while protecting drive shaft threads from damage. The front speed sensor bolt should be removed before separating the sensor to maintain cleanliness while you dismantle the front stabilizer link through the detached nut. The procedure for separating the tie rod end sub-assembly begins with removing the cotter pin and castle nut before installing Special Service Tool: 09960-20010 (spacer B) to the tie rod end and using Special Service Tool: 09960-20010 09961-02010 while ensuring to secure the tool onto the vehicle body to prevent accidental drops. The procedure for the front lower suspension arm requires use of identical special tools and safety measures as the previous steps. Separating the front axle assembly requires a light tapping of the drive shaft end with a plastic hammer or brass bar if needed before pushing the front axle out from the vehicle while maintaining the drive shaft suspension. Cut off the LH-drive assembly of the front shaft through the application of Special Service Tools: 09520-01010 09520-24010 while using a screwdriver with hammer to detach the RH drive shaft assembly but be mindful of preserving the oil seal along with inboard boot. The front axle assembly requires anchoring with Special Service Tool: 09608-02021: 09608-16042 09608-02041 while supporting the hub bearing if the vehicle rests on its complete weight.