Other Name: Pipe Assembly, Exhaust; Exhaust Pipe; Pipe Assembly, Exhaust, Center
Position: Center
Part Name Code: 17420
Item Weight: 7.50 Pounds
Item Dimensions: 34.0 x 3.6 x 17.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 17420-28520
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2008 Scion tC Submodels:
Base, Spec | 4 Cyl 2.4 L GAS
2008 Scion tC Exhaust Pipe
Looking for affordable OEM 2008 Scion tC Exhaust Pipe? Explore our comprehensive catalogue of genuine 2008 Scion tC Exhaust Pipe. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2008 Scion tC Parts Questions & Experts Answers
Q: How to install the exhaust pipe and ensure proper assembly on 2008 Scion tC?
A: The installation of the exhaust pipe begins with installing five exhaust pipe supports to the body of the vehicle. A vernier caliper should be used to check the compression spring free length and replacement is needed if the measurement falls below 40.5 mm (1.594 in.). Mount a new exhaust gasket in a flush position to the exhaust manifold through wooden block hammering with a plastic-faced hammer while maintaining proper orientation and discarding any repeat use. Fasten the front exhaust pipe by installing two compression springs and two bolts while torquing them to 43 Nm (440 kgf-cm, 32 ft-lbf). The installation procedure for the center exhaust pipe assembly requires a new gasket placement onto the front exhaust pipe followed by connecting the center exhaust pipe to its supports before bolting it with 2 fasteners that should be torqued to 43 Nm (440 kgf-cm, 32 ft-lbf). The tailpipe installation process requires checking the compression spring length; replace it if the measurement shows below 38.5 mm (1.516 in.). Install a fresh gasket next to the exhaust pipe center but position it correctly to prevent recycling. Attach the tailpipe to the 3 supports before installing 2 compression springs along with 2 bolts which must achieve a torque of 43 Nm (440 kgf-cm, 32 ft-lbf). The Bank 1 Sensor 2 heated oxygen sensor needs installation followed by cable connection to the negative terminal of the battery while searching for exhaust gas leaks. The front floor panel brace needs four bolts which must be torqued to 29.6 Nm (300 kgf-cm, 22 ft-lbf) while maintaining proper installation orientation. When re-establishing the power connection to the negative battery terminal systems that need initialization must be activated.