Other Name: Sensor Assembly, Side Air Bag; Air Bag Impact Sensor, Front Right; Air Bag Sensor; Side Sensor; Sensor Assembly, Side Air Bag, Passenger Side
Manufacturer Note: SRS AIR BAG-W(SIDE & CURTAIN SHIELD)
Position: Passenger Side
Part Name Code: 89860
Item Weight: 0.60 Pounds
Item Dimensions: 4.3 x 2.6 x 2.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89860-21031
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Sensor, Seat Position; Seat Track Position Sensor, Left; Sensor, Seat Position Air Bag
Position: Driver Side
Part Name Code: 89178A
Item Weight: 0.50 Pounds
Item Dimensions: 2.1 x 1.5 x 1.4 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89178-33040
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2008 Scion tC Submodels:
Base, Spec | 4 Cyl 2.4 L GAS
2008 Scion tC Air Bag Sensor
Looking for affordable OEM 2008 Scion tC Air Bag Sensor? Explore our comprehensive catalogue of genuine 2008 Scion tC Air Bag Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2008 Scion tC Parts Questions & Experts Answers
Q: How to install the side Air Bag sensor assembly on the LH side on 2008 Scion tC?
A: The LH side installation of the side Air Bag sensor assembly needs 2 nuts and a bolt to secure it with a torque of 9.0 Nm (92 kgf-cm, 82 in-lbf). A sensor replacement must happen when there is evidence of drops or visible cases of cracks or dents or defects found in the case, bracket, or connector unit. The wire leading to the SRS system must be handled carefully to prevent contact with other components when installation occurs. Verify through a post-installation check whether the sensor base properly fits its mounting point. Perform the installation of front door service hole cover LH, front door inside handle sub-assembly LH and front door trim board sub-assembly LH after connecting the sensor connector. To complete installation arrange the switch connector for the front armrest base panel upper LH and apply the clip and 5 claws for securing the master switch with other components. Secure the assist grip cover together with the front door lower frame bracket garnish LH. When the cable attaches to the negative battery terminal users should perform initialization because some systems need this process following battery replacement. An inspection of the SRS warning light will reveal necessary system functionality.