Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2007 Toyota RAV4 Submodels:
Base, Limited | 6 Cyl 3.5 L GAS
2007 Toyota RAV4 Coil Springs
Looking for affordable OEM 2007 Toyota RAV4 Coil Springs? Explore our comprehensive catalogue of genuine 2007 Toyota RAV4 Coil Springs. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2007 Toyota RAV4 Parts Questions & Experts Answers
Q: How do you service the rear coil spring on 2007 Toyota RAV4?
A: Service of the rear coil spring starts with removing the rear wheel followed by disconnection of the skid control sensor wire in 2WD vehicles or the rear speed sensor LH in 4WD vehicles. The service of the rear coil spring begins with the removal of the rear wheel followed by separating the No. 2 parking brake cable assembly and the rear stabilizer link assembly LH and the rear suspension No. 2 arm sub-assembly LH through bolt loosening on the suspension member side while retaining the bolt and then supporting the No. 2 suspension arm LH with a jack (placed between jack and arm with a wooden or rubber block) before removing the bolt and nut from the axle carrier side while lowering the jack slowly for complete disconnection. commence by taking out the rear coil spring insulator upper LH and then the rear coil spring LH before removing the rear coil spring insulator lower LH from the suspension No. 2 arm. Installation of the rear coil spring system begins with the placement of the rear coil spring insulator lower LH and proceeds with installation of the rear coil spring LH followed by the rear coil spring insulator upper LH while verifying that the stopper part faces the coil spring tip. The suspension No. 2 arm needs temporary support from a jack to join it with the axle carrier where technicians should install the bolt and nut with the coil spring's distinguishing mark facing the vehicle's external side. The next steps require attachment of the rear stabilizer link assembly LH followed by reattachment of the No. 2 parking brake cable assembly and reinstalling the skid control sensor wire for 2WD or the rear speed sensor LH for 4WD before reinstalling the rear wheel and torque it to 103 Nm (1,050 kgf-cm, 76 ft. lbs.). After completing the check of speed sensor signal and rear wheel alignment the next step is to stabilize the suspension followed by tightening the rear suspension No. 2 arm assembly LH.