OEM 2007 Toyota Corolla ABS Control Module

2007 Toyota Corolla Parts Questions & Experts Answers

• Q: How to service and repair the ABS Control Module for Antilock Brakes on 2007 Toyota Corolla?

  A: The service process for the Hydraulic Control Assembly for Antilock Brakes starts with draining brake fluid before cleaning all paint surfaces touched by fluid residue. The service begins by eliminating the RH front wheel and both the front fender liner RH and radiator grille sub-assembly and front bumper cover and LH headlight assembly and windshield washer jar assembly. The brake actuator with bracket gets removed through the process of disconnecting the actuator connector followed by using Special Service Tool: 09023-00101 to detach the six brake tubes. Rephrase the connection labels before unscrewing the 2 bolts and nut that anchors the actuator with bracket while being cautious about brake tubes and wire harness damage. Move on to remove the brake actuator assembly after unfastening the 2 nuts which secure it. The brake actuator assembly must first be fit to the bracket where it receives 2 installation nuts before torquing force reaches 6.0 N.m (61 kgf.cm, 53 in.lbf). You must first ensure bracket and actuator installation with 2 bolts along with a nut then secure them by applying 20 N.m (204 kgf.cm, 15 ft.lbf) torque while properly sequencing bolt tightening and securing the actuator connector. All brake tube connections to the actuator with bracket should be made using Special Service Tool: 09023-00101 and torqued up to 15 N.m (155 kgf.cm, 11 ft.lbf). The windshield washer jar assembly together with LH headlight assembly and front bumper cover and radiator grille sub-assembly and front fender liner RH and front wheel RH must be installed before torquing the wheel to 103 N.m (1,050 kgf.cm, 76 ft.lbf). The technician should start by providing brake fluid to the reservoir before bleeding the master cylinder along with the brake line while checking the fluid level and looking for any brake fluid leaks. Test the actuator using an intelligent device after which the vehicle must be put ready for fog light aiming adjustment then test and adjust the fog light aiming position before starting the process of headlight aiming preparation with necessary inspections and adjustments.