OEM 2006 Toyota Corolla ABS Control Module

2006 Toyota Corolla Parts Questions & Experts Answers

• Q: How to Replace the ABS Control Module in the Hydraulic Control Assembly for Antilock Brakes on 2006 Toyota Corolla?

  A: The first step in replacing the Brake Actuator Assembly requires draining brake fluid followed by cleaning any adhesive fluid from painted surfaces. The first step in this process involves removing the front wheel RH together with the front fender liner RH and radiator grille sub-assembly and front bumper cover and LH headlamp assembly and windshield washer jar assembly. The removal process begins by disconnecting the actuator connector along with the use of Special Service Tool: 09023-00101 to detach the 6 brake tubes from the actuator with bracket. Note down the connection order for accurate reassembly. Detach the actuator with bracket by unbolting its 2 screws and removing the nut while being cautious about brake tube and wire harness safety. The brake actuator requires removal from its bracket after taking off both retaining nuts. To install the brake actuator with bracket connect the unit to the bracket through two 6.0 Nm (61 kgf-cm, 53 inch lbs.) torque followed by attaching the actuator with bracket to the two bolts and nut which require 20 Nm (204 kgf-cm, 15 ft. lbs.) torque. Complete installation by making sure the brake tubes and wire harness remain undamaged and using sequence from 1 to 3 to tighten bolts. Install Special Service Tool: 09023-00101 then tightly torques brake tubes to their respective points on the actuator with bracket to 15 Nm (155 kgf-cm, 11 ft. lbs.). The technician should install the windshield washer jar assembly followed by the LH headlamp assembly and both the front bumper cover and the radiator grille sub-assembly and finally the front fender liner RH and front wheel RH, torquing the wheel to 103 Nm (1,050 kgf-cm, 76 ft. lbs.). Insert brake fluid into the reservoir before performing master cylinder bleeding with tool 09023-00101 together with brake line bleeding and reservoir fluid level inspection while checking for fluid leaks and manually testing the actuator. Follow the Fog Lamp aim adjustment procedures and conduct Fog Lamp aiming tests before beginning Headlamp aiming tests utilizing a tester and screen which will end in the inspection and adjustment of Headlamp aiming.