OEM 2006 Toyota Sequoia ABS Control Module

2006 Toyota Sequoia Parts Questions & Experts Answers

• Q: How to service and repair the ABS Control Module for Antilock Brakes on 2006 Toyota Sequoia?

  A: Begin hydraulic control assembly assembly service by disconnecting the connector using a pull of the release bar. Special Service Tools 09023-00101, 09023-38201 should be used to separate six brake lines from the actuator assembly by torquing the 10 mm nut to 15 N.m (155 kgf.cm, 11 ft.lbf) and the 12 mm nut to 19.5 N.m (195 kgf.cm, 14 ft.lbf). The installation process will be easier with brake line tags for future reconnection. Start by removing the 3 nuts which secure the actuator bracket from the ABS and traction assembly and then torques the parts to 11 N.m (112 kgf.cm, 8 ft.lbf). The disassembly process starts by taking off 3 bracket No.1 bolts with 9.5 N.m (97 kgf.cm, 84 ft.lbf) torque followed by extracting the 3 cushions from the actuator bracket. An E5 "Torx" wrench should be used for removing the 3 screws that hold down the skid control ECU while torquing them to 1.8 N.m (18 kgf.cm, 16 ft.lbf). Protect the actuator surface by using plastic tools or soft objects during cleaning regardless of the necessity for chemical solvents. After recovering every part the return order begins with the installation of components that match their disassembly sequence. Brake fluid must be added to the reservoir following installation along with brake system bleeding before leak inspection. The replacement of a skid control ECU requires performing zero point calibrations for steering angle and master cylinder pressure sensors together with yaw rate and deceleration sensors.