OEM 2005 Toyota Sequoia Power Steering Pump

2005 Toyota Sequoia Power Steering Pump Parts Q&A

• Q: How to install the Power Steering Pump on 2005 Toyota Sequoia?

  A: Start the power steering vane pump installation by mounting the PS vane pump assembly with the stud bolt at 22 Nm (220 kgf-cm, 16 ft. lbs.) torque and installing the 2 bolt along with its nut that needs tightening to 44 Nm (450 kgf-cm, 33 ft. lbs.). Begin by installing the pressure feed tube while placing the new gasket correctly and torquing the union bolt to 46.5 Nm (475 kgf-cm, 34 ft. lbs.). Validate that the pressure feed stopper reaches the PS vane pump body. Secure the return hose by using the clip and connect the two vacuum hoses by employing their individual clips. A technician should loosen the drive belt tension through counterclockwise rotation of the drive belt tensioner before drive belt installation. Secure the air cleaner assembly by installing its hose and 3 bolts first followed by the clamp which will establish connections between hoses and MAF meter connector. To end the power steering system installation you must bleed it.