How to service and repair the Parking Brake Cable Assembly No.3 on 2005 Toyota Corolla?

Question

Accepted Answer

The starting point for servicing or repairing the Parking Brake Cable Assembly No.3 includes removing the rear wheel along with the rear brake drum sub-assembly from the vehicle (drum rear brake type). First remove the rear brake automatic adjust lever LH and then remove the front brake shoe followed by the parking brake shoe strut set LH using Special Service Tool: 09718-00010. The service continues with removal of the rear brake shoe. The service procedure starts by disconnecting the rear disk brake caliper assembly LH followed by removal of the rear disk. The mechanic should eliminate the parking brake shoe strut LH and the parking brake shoe adjusting screw set and the parking brake shoe assembly LH No.1 and No.2 and the parking brake shoe lever together with the parking brake shoe strut LH. Disconnect the parking brake cable assembly No.3 through the removal of its bolt and separation from the backing plate connection. The removal procedure starts with disassembling the exhaust pipe assembly front at its location beside the front floor heat insulators No.1 and No.2 through 5 bolts followed by the fuel tank protector No.1. Remove the parking brake cable assembly No.3 through a process of disconnecting the skid control sensor wire harness clip from its clamp followed by removing 4 bolts along with the cable retainer from the body before detaching it from the equalizer. Install the new parking brake cable assembly No.3 on the equalizer by attaching it then bolt it down with the 4 bolts and secured with the cable retainer which must be torqued to 5.4 Nm followed by reconnecting the skid control sensor wire harness clip. After installing the fuel tank protector No.1 using its 5 bolts torqued at 5.5 Nm users must install the front floor heat insulators and exhaust pipe assembly front. The parking brake cable assembly No.3 requires installation on the backing plate through bolt application (7.8 Nm for drum rear brake type while disc rear brake type requires 8.0 Nm torque). Use high-temperature grease with Special Service Tool: 09718-00010 to apply on both drum and disc rear brakes before installing the rear brake shoes together with the parking brake shoe strut set LH and front brake shoe. Projection of the rear brake automatic adjust lever LH needs completion followed by drum brake inspection to reinstall the rear brake drum subassembly. Adjust the clearance of the rear drum brake shoes before putting back the rear wheel (torque to 103 Nm). While performing the installation of the disc rear brake type use high-temperature grease to install all components including the parking brake shoe lever LH as well as parking brake shoe assembly LH No.2 and No.1 and the parking brake shoe adjusting screw set and parking brake shoe strut LH. After parking brake installation verify its proper positioning then install the rear disc before adjusting the parking brake shoe clearance while connecting the rear disc brake caliper assembly LH. Check the parking brake lever travel along with the vehicle exhaust for any leakage as the final step.

OEM 2005 Toyota Corolla Parking Brake Cable

7 Parking Brake Cables found

2005 Toyota Corolla Rear Cable

2005 Toyota Corolla Rear Cable

2005 Toyota Corolla Rear Cable

2005 Toyota Corolla Rear Cable

2005 Toyota Corolla Rear Cable

2005 Toyota Corolla Front Cable

2005 Toyota Corolla Rear Cable

2005 Toyota Corolla Parking Brake Cable

2005 Toyota Corolla Parts Questions & Experts Answers

Related 2005 Toyota Corolla Parts

Alternate Year Models