Other Name: Belt Assembly, Front Seat; Seat Belt Lap and Shoulder Belt, Front Right; Belt & Retractor; Belt Assembly, Front Seat Outer, Passenger Side
Manufacturer Note: OAK,TRIM4#
Position: Passenger Side
Part Name Code: 73210
Item Weight: 4.20 Pounds
Item Dimensions: 13.1 x 9.2 x 6.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 73210-04121-E0
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2004 Toyota Tacoma Submodels:
Base, Pre Runner, S-Runner | 4 Cyl 2.4 L GAS, 4 Cyl 2.7 L GAS, 6 Cyl 3.4 L GAS
| Page 1 of 2 |Next >
1-20 of 36 Results
2004 Toyota Tacoma Seat Belt
Looking for affordable OEM 2004 Toyota Tacoma Seat Belt? Explore our comprehensive catalogue of genuine 2004 Toyota Tacoma Seat Belt. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2004 Toyota Tacoma Seat Belt Parts Q&A
Q: What is the correct method for installing a new seat belt tongue plate stopper and inspecting the seat belt webbing for damage on 2004 Toyota Tacoma?
A: The new service part of the seat belt tongue plate stopper requires installation procedures to support seat belt maintenance. The tongue plate needs positioning on the upper end of the tongue plate stopper while being held by clips or tape until replacement is ready. Use pliers to remove all leftover parts from your original tongue plate stopper that is present in the webbing. A seat belt assembly must be replaced whenever webbing exhibits cut or frayed or damaged tissue or if it sustained serious impact; complete webbing inspection should reveal damage before installing a new assembly while avoiding webbing damage in the repair process. Secure a new tongue plate stopper in the webbing hole by placing it the right way before finishing installation. Use an adjustable wrench to pinch the tongue plate stopper inside the webbing before aligning the male and female pieces parallel through hand twisting and pushing of the adjustment screw. Pliers should not be used due to potential damage of the webbing material. The adjustment screw of the adjustable wrench needs adjustable joint pliers to achieve a controlled screw tightening which establishes the adjustable wrench jaw opening at 4.5 - 5.0 mm (0.18 in. - 0.20 in.). Verify that the male pin of the tongue plate stopper has properly stretched into the female part to firmly secure onto the webbing belt.