The protocol to remove the Access Cab's front seat outer belt assembly begins with disconnecting the negative battery terminal cable followed by a 90-second patient before proceeding. The first step involves removing both the access panel rear
Weather Strip then the lap belt outer anchor cover. The door pull handle must be separated first by removing its screw followed by accessing the inside handle bezel panel through its protective tape-wrapped screwdriver opening cover and screw removal step. To remove the rear door trim board sub-assembly you must first separate the bolt from the floor anchor of the front seat outer belt then unclip the door and disconnect the 9 clips from the trim board. Remove the access panel inside handle sub-assembly before removing the front seat outer belt assembly by first unscrewing the nut and should anchor and disconnecting the pretensioner connector and then taking out the 2 bolts and retractor. To complete the removal process the front shoulder belt anchor adjuster assembly needs both bolt removal and disconnection of its 2 claws.