Toyota 90311-89015
Seal, Engine Rear Oil

The first step to install the rear crankshaft oil seal requires application of MP grease to the lip of a new oil seal while ensuring both foreign matter stays away from the lip and MP grease avoids the dust seal. Special Service Tools 09223-15030 and 09950-70010 with a hammer will help install the oil seal into position until its surface matches the cylinder block and crankcase edges. Keep the lip free of foreign matter and avoid hitting at any angle. After positioning Special Service Tool: 09213-54015 and 91551-80650 on the crankshaft clean all bolts and their installation holes before installing the front drive plate spacer while its pin faces the crankshaft pin hole. Maintain an equivalent of 2 or 3 bolt threads on the drive plate end with Toyota Genuine Adhesive 1324 or Three Bond 1324 while tightening the 8 bolts to a torque of 98 Nm (999 kgf-cm, 72 ft-lbf) until evenly distributed. The installation of the automatic transaxle should be performed for 2WD while the appropriate AWD installation procedure needs to be followed. Place the engine together with transaxle assembly for installation.

Special Service Tool: 09223-22010 and a hammer.