Toyota 85500-28050
Lighter Assembly, Cigarette

The service on the cigarette lighter assembly begins by disconnecting the negative cable from the battery terminal then waiting at least 90 seconds to deactivate the Air Bag pretensioners and seat belt pretensioners. The procedure begins by removing the instrument cluster finish panel center followed by the heater control knob and instrument cluster finish panel sub-assembly lower center and the cigarette lighter cover requires the detachment of its two claws. The cigarette lighter assembly removal starts by removing the cigarette lighter knob and element then turning the socket until the claw between the socket and cigarette lighter bezel stay disengages finally pulling out the socket. Put the socket in line with the notch present on the cigarette lighter bezel stay then pull out the cigarette lighter. To install the cigarette lighter place the socket into the notch on the cigarette lighter bezel stay before pushing it into place strongly and adding the component elements and knob. Use the 2 claws to fix the cigarette lighter cover before moving to the instrument cluster finish panel sub-assembly lower center and instrument cluster finish panel center and installing the heater control knob. Reestablish the cable connection to the battery terminal which has a negative charge.

Starting the cigarette lighter assembly replacement process requires disconnecting the negative terminal from the battery. The work starts with removing instrument cluster finish panel garnish No.2 followed by instrument cluster finish panel garnish No.1. To access the front ash receptacle assembly and cigarette lighter cover start by dislodging their 2 respective claws. After removing the cigarette lighter knob and element assembly the process continues with turning the socket as indicated to detach the claw between the socket and cigarette lighter bezel stay and finally pulling out the socket. Move the socket against the notch located on the cigarette lighter bezel stay to pull out the cigarette lighter assembly. During installation align the socket with its corresponding slot in the cigarette lighter bezel stay and apply strong pressure to the cigarette lighter assembly to finish. Finish the task by reattaching both the cigarette lighter knob and element assembly.

The service of the cigarette lighter requires disconnecting the negative battery terminal cable and letting a minimum time of 90 seconds pass before proceeding to avoid Air Bag and seat belt pretensioner activation. The servicio completo commences with the removal of No. 2 instrument cluster finish panel garnish before doing No. 1. Remove the front ash receptacle assembly and the cigarette lighter cover by detaching the 2 claws. The procedure to remove the cigarette lighter assembly starts with unscrewing and removing the cigarette lighter knob and element. Then turn the socket and pull the assembly by disengaging the claw from the socket and cigarette lighter bezel stay. Insert the socket into the notch of the cigarette lighter bezel stay for removing the cigarette lighter unit. To assemble the cigarette lighter you need to push it in tightly after positioning the socket notch correctly and proceed with inserting the knob and element. The first step is attaching the two claws to secure the cigarette lighter cover then proceeding with installation of the front ash receptacle assembly while finishing with the No. 2 instrument cluster and the No. 1 instrument cluster. After connecting the cable to the negative battery terminal users must complete initialization steps for some systems which need this procedure when disconnecting then reconnecting the cable.

First, disconnect the battery negative terminal.

Remove the instrument cluster finish panel garnish No.2.

Take off the cigarette lighter knob and element assembly, turn the socket as indicated to disengage the claw between the socket and the cigarette lighter bezel stay, and pull out the socket.