Toyota 53611-AA010-A0
Cable Handle, Front

Begin installation of the hood cable assembly by inserting it through the engine compartment before guiding it through the upper radiator support and finishing the clamps engagement. The installation process requires the lower No. 1 instrument panel finish panel followed by the cowl side trim sub-assembly LH and finishes with the front door scuff plate LH. The installation procedure of this hood lock assembly without the engine hood courtesy switch requires applying MP grease to the lock sliding areas followed by connecting the hood cable then using three bolts torque to specified values: centering bolt at 8.0 Nm (82 kgf-cm, 71 in-lbf), standard bolt at 7.5 Nm (77 kgf-cm, 66 in-lbf) and the other bolt 8.0 Nm (82 kgf-cm, 71 in-lbf). The last step requires the installation of a fresh hood lock nut cap. After performing the same preliminary procedures on the hood lock assembly which has the engine hood courtesy switch users need to attach the connector followed by the new hood lock nut cap installation. Mount the high-pitched horn assembly together with the radiator grille, radiator grille protector and cool air intake duct seal using three new grommets, eight screws, a bolt and four clips while inserting the pin hold clip with vertical slot alignment. The front wheel needs to be installed LH side with 76 ft-lbf torque (1050 kgf-cm, 103 Nm) and the LH front fender mold should be installed simultaneously. A thorough examination of the hood sub-assembly should be performed followed by necessary adjustments.

Follow the same initial steps, connect the connector, and install a new hood lock nut cap.

Take off the front fender outside moulding LH.

Remove the front door scuff plate LH, cowl side trim sub-assembly LH, and lower No. 1 instrument panel finish panel.