Toyota 75441-08020
Emblem

A vehicle body heat light should be used to warm the emblem and rear body and back door name plates while ensuring the components remain safe from overheating. Start the process by taping the emblem before inserting a piano wire through the joint between the badge and body which should focus on the boss position. Selection of wooden blocks or similar objects allows you to attach them to both ends of the wire before pulling the wire to remove the double-sided tape securing the emblem while guarding against body damage. The process for removing double-sided tape from the rear body name plate involves first applying protective tape followed by inserting a piano wire that enables the attachment of wooden blocks to its ends. The wire is then pulled to strip off the tape while the operator removes the name plate with caution to prevent body damage. The last step includes back door name plate protection with tape while using piano wire to scrape off double-sided tape through pulling the wire between vehicle body and name plate until successful removal is possible while maintaining body integrity.

Clean the vehicle body surface, then heat it with the heat light and remove the double-sided tape, wiping off any adhesive residue with cleaner.

Follow the same cleaning and heating steps, remove the peeling paper, and install it in the designated position, again pressing firmly to secure it.

First, heat the vehicle body, emblem, rear body name plate, and back door name plate using a heat light, ensuring not to overheat any components.