Toyota 86101-48490
Antenna Cable, Rear

Tape the antenna cord sub-assembly No. 3 at the designated position on the roof headlining, ensuring it is centered on a piece of tape measuring 100 mm x 25 mm, while avoiding contact with the adhesive side of the tape.

Disconnect the cable from the negative battery terminal and wait 90 seconds to prevent airbag activation.

Remove the tonneau cover assembly, deck board sub-assemblies (with or without rear No. 2 seat), deck floor boxes, rear floor finish plate, back door weatherstrip, rear seat reclining covers (LH and RH, with rear No. 2 seat), jack carrier assembly, deck side trim boxes LH and RH, rear seat track bracket covers (inner and outer, with or without rear No. 2 seat), rear No.1 seat assemblies (LH and RH, with or without rear No. 2 seat), reclining hinge cover (with rear No. 2 seat), front door opening trim weatherstrips LH and RH, rear door scuff plates (LH and RH, with or without rear No. 2 seat), center pillar garnishes (lower LH and RH), separate front seat outer belt assemblies (LH and RH), remove deck side trim covers (front LH and RH, and LH and RH, with or without rear No. 2 seat), separate rear No.1 seat belt assemblies (outer LH and RH), remove rope hook, and deck trim side panel assemblies (LH and RH, with or without rear No. 2 seat), quarter pillar garnishes (LH and RH), roof side rail garnish subassemblies (LH and RH), separate rear No.2 seat belt assemblies (outer LH and RH, with rear No. 2 seat), remove roof side garnishes (inner LH and RH, with or without rear No. 2 seat), assist grip sub-assembly, room light assemblies (No.1 and No.2), roof console box assembly, visors (LH and RH), visor holder, television base and display (with rear seat entertainment system), and roof headlining assembly (with or without rear No. 2 seat).

Reinstall the roof headlining assembly.