OEM Toyota Venza Fuel Pressure Regulator

Toyota Venza Fuel Pressure Regulator Parts and Q&A

• Fuel Pressure Regulator
  23280-21010
  Q: How to Properly Install a Fuel Pressure Regulator on Toyota Venza?

  A:

  Install the fuel pressure regulator assembly by applying gasoline to two new O-rings before putting them on the fuel pressure regulator. You should mount the fuel pressure regulator onto the fuel filter. Begin by installing the fuel pump assembly with filter and after that install the fuel filter assembly. Install the fuel sender gauge subsequently before completing the installation with the fuel suction tube assembly that contains both the pump and gauge.
• Damper
  23270-36031
  Q: How to Service and Repair the Fuel Pressure Regulator on Toyota Venza?

  A:

  Starting the fuel system pressure discharging process is required before dismantling the fuel pressure pulsation damper. It is necessary to disconnect the cable from the negative terminal while keeping in mind certain systems need initialization after reconnection. Start by removing the windshield Wiper Motor together with its link assembly after which you should separate the outer cowl top panel. The No. 1 vacuum switching valve assembly and the No. 1 engine cover sub-assembly need to be detached. The next step involves removing the air cleaner cap sub-assembly and the fuel tube sub-assembly while always avoiding fuel tube deformities. Begin by removing the fuel tube from its clamp on the fuel hose followed by loose of No. 2 fuel pipe clamp and cleaning the dirt from the fuel tube connector. The Special Service Tool 09268-21010 enables connection disconnection of fuel tube connector by sliding the retainer onto the tool's chamfered section and moving the connector towards it until the tool produces a "click" sound. Unfasten the No. 1 fuel pipe clamp then squeeze the tube connector before pulling it away from the pipe while inspecting for any foreign material while preserving the cleanliness of the pipe and connector. The fuel pressure pulsation damper assembly needs to be removed by unfastening its 2 bolts and the damper and discarding the O-ring from the damper.