Installation of the A750E automatic transmission valve body assembly requires users to first install the spring and check ball body and then feed the manual valve pin through its hole in the lever. The installation process requires 19 bolts of which bolt A extends to 36 mm (1.42 in.) while bolt B reaches 25 mm (0.984 in.). Both bolt sets need a torque of 11 Nm (112 kgf-cm, 8 ft-lbf). Begin with installing the detent spring cover and spring while using a bolt then apply 10 Nm (102 kgf-cm, 7 ft-lbf) of torque. Attach the transmission wire before installing both the valve body oil strainer assembly and afterwards the automatic transmission oil pan sub-assembly. Attach the cable to the negative battery terminal of the system yet systems with specific initialization requirements may need service and automatic transmission fluid must be replenished.