Other Name: Lamp Assembly, Rear, Right-Hand; Back Up Light Assembly, Rear Right; Tail Light Assembly; Other Lamp; Lamp Assembly, Rear, Passenger Side; Back Up Light
Position: Passenger Side
Fits the following Toyota Models:
Highlander | 2020-2023 | Hybrid Bronze Edition, Hybrid LE, Hybrid Limited, Hybrid Platinum, Hybrid XLE, L, LE, Limited, Platinum, XLE, XSE | 4 Cyl 2.4 L GAS, 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 6 Cyl 3.5 L GAS
Camry | 2021-2024 | Hybrid LE, Hybrid SE, Hybrid SE Nightshade, Hybrid XLE, Hybrid XSE, LE, SE, SE Nightshade, TRD, XLE, XSE | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L GAS, 6 Cyl 3.5 L GAS
Camry | 2021-2024 | Hybrid LE, Hybrid SE, Hybrid SE Nightshade, Hybrid XLE, Hybrid XSE, LE, SE, SE Nightshade, TRD, XLE, XSE | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L GAS, 6 Cyl 3.5 L GAS
Other Name: Lamp Assembly, Rear, Right-Hand; Back Up Light Assembly, Rear Right Inner; Tail Light Assembly; Other Lamp; Lamp Assembly, Rear, Passenger Side; Back Up Light
Position: Passenger Side
Fits the following Toyota Models:
Highlander | 2017-2019 | Hybrid LE, Hybrid Limited, Hybrid Limited Platinum, Hybrid XLE, LE, LE Plus, Limited, Limited Platinum, SE, XLE | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L FULL HYBRID EV-GAS (FHEV), 6 Cyl 3.5 L GAS
| Page 1 of 51 |Next >
1-20 of 1013 Results
Toyota Tail Light Parts Questions & Experts Answers
A: The first step to remove the rear light assembly involves disconnecting two claws and two guides which allow the removal of the luggage compartment side cover. The first step requires disconnecting the connector followed by unthreading both nuts to free the rear light assembly before finishing the task with clip disengagement.
Q: How to install the rear Tail Light assembly on Toyota RAV4?
A: The installation of the rear combination light assembly begins by affixing the clip which secures the light while you install three nuts before connecting the connector. Connect the cable to the negative battery terminal as the final step of the procedure. The installation routine for the LH side should mirror the procedures applied to the RH side.
Q: What steps are involved in overhauling a Tail Light assembly on Toyota Prius?
A: You should start your work on the rear combination lamp assembly by taking off the rear combination lamp service cover LH. Start by removing the rear combination lamp assembly by eliminating its 2 nuts followed by pin movement backing the car and connector disconnection until the lamp assembly can be extracted. You must remove all bulb sockets along with their 3 associated rear combination lamp bulbs.