Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
1995-1997 Toyota Tacoma | Base, SR5 | 6 Cyl 3.4 L GAS
| Page 1 of 4 |Next >
1-20 of 68 Results
Toyota Tacoma Exhaust Pipe
If you're thinking about purchasing OEM parts for your Toyota Tacoma, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Tacoma Exhaust Pipe at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Tacoma Exhaust Pipe Parts Questions & Experts Answers
Q: How to install the exhaust pipe assembly on Toyota Tacoma?
A: The installation of the 2TR-FE exhaust pipe assembly begins with verifying the compression spring length using vernier calipers for minimum 40.5 mm (1.594 in.). A shorter number indicates the need to replace the compression spring. A wooden block along with a plastic-faced hammer should be used to install a new gasket until it is properly situated flush with the exhaust manifold while maintaining the correct angle. Always use new gaskets instead of reusing the old ones. Avoid inserting the new gasket into the exhaust manifold when you put on the exhaust pipe front. Screw the exhaust pipe front into the exhaust pipe support while tightening both bolts and compression springs at 43 Nm (438 kgf-cm, 32 ft-lbf). To attach the exhaust pipe tail, users should place a new gasket onto the exhaust pipe front before securing the pipe tail to its 4 supports and setting the 2 bolts and 2 nuts to 48 Nm (489 kgf-cm, 35 ft-lbf). Fasten the Oxygen Sensor and air fuel ratio sensor onto their respective positions before attaching the cable to the negative battery terminal with 3.9 Nm (40 kgf-cm, 35 in-lbf) torque. Perform a last examination of exhaust gas leakage.