Other Name: Emblem, Back Door; Deck Lid, Rear; Grille, Front; Hatch, Rear; Hood, Front; Door, Rear; Emblem, Radiator Grille (Or Front Panel); Emblem, Symbol
Replaces: 90975-02072
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2008-2022 Toyota Sequoia | Limited, Nightshade, Platinum, SR5, TRD Pro, TRD Sport | 8 Cyl 4.6 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FLEX, 8 Cyl 5.7 L GAS
Other Name: Plate, Roof Side Nam; Quarter Panel Emblem, Rear; Door Emblem, Front; Door Emblem, Rear; Mark, Roof Side, Passenger Side; Driver Side; Front Door Name; Roof Side Name
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2008-2022 Toyota Sequoia | Limited | 8 Cyl 5.7 L FLEX, 8 Cyl 5.7 L GAS
Other Name: Plate, Engine Name; Engine Cover Emblem; Nameplate
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2001-2002 Toyota Sequoia | Limited, SR5 | 8 Cyl 4.7 L GAS
| Page 1 of 2 |Next >
1-20 of 27 Results
Toyota Sequoia Emblem
If you're thinking about purchasing OEM parts for your Toyota Sequoia, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Sequoia Emblem at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Sequoia Emblem Parts Questions & Experts Answers
A: The body emblem removal process requires protective tape near the No. 1 roof side mark before threading a piano wire through the rear door panel. The wire ends get secured with wooden blocks for pull-off handles. Use the wire to scrape off the double-sided tape before removing the No. 1 roof side mark with care. Protective tape should be applied over the symbol emblem area on the back door panel after the body is passed through with piano wire. Wooden blocks function as handles during this process. The double-sided tape will dissolve by pulling the wire thus allowing you to detach the symbol emblem. The procedure for removing the No. 4 back door name plate requires protective tape application on the back door panel followed by piano wire passage between the body and the name plate before removing the name plate with wooden block handles. Repeat these steps to remove the No. 3 and No. 5 back door name plates after using protective tape and passing piano wire between the vehicle body and name plates then removing them safely.