You must attach the wire harness clamp bracket through a bolt that needs 8.4 Nm of torque (86 kgf-cm, 74 in-lbf). Fasten the generator assembly with two bolts at 21 Nm (215 kgf-cm, 16 ft-lbf) for Bolt A and 52 Nm (530 kgf-cm, 38 ft-lbf) for Bolt B. Fit the wire harness at terminal B by torquing the retaining nut to 9.8 Nm while building the generator connector together with the two wire harness clamps. After installing the V-ribbed belt you should put on the engine under cover RH then connect the cable to the negative terminal of the battery.