Q: How to replace the Cruise Control Module on Toyota Corolla?
A: Begin the replacement of Cruise Control ECU Assembly (1ZZ-FE) by uninstalling meter hood sub-assembly before proceeding to combination meter assembly. You should disconnect the connector along with removing the screw to extract the cruise control ECU assembly.
Q: How to remove the Cruise Control Module on Toyota Sequoia?
A: Starting the Cruise Control Module removal process requires users to start by taking out the front door scuff plate LH before touching the cowl side trim board LH. Begin by separating the front door opening trim Weather Strip LH and afterward remove the instrument side panel LH. The technician needs to take out the hood lock control lever sub-assembly along with the lower instrument panel finish panel sub-assembly from left-hand side. Take out the No. 1 instrument panel safety pad insert before separating the main body ECU (cowl side junction block LH). Unplug the connector while removing the bolt in order to remove the distance control ECU assembly.
Q: How to service the Cruise Control Module on Toyota Sienna?
A: You should start Cruise Control Module servicing by taking off the glove compartment door stopper sub-assembly and glove compartment door assembly. The service starts by taking out the stereo component amplifier assembly combined with the stereo component amplifier while next you should remove the distance control ECU assembly through a two-step process of bolt removal followed by clip disengagement. During assembly mount the distance control ECU assembly through the utilize of a torque wrench to tighten down the bolt with 5 N.m (51 kgf.cm, 44 in.lbf) torque. A dropped or shocked distance control ECU assembly should never be installed into the system.