The installation of the rear seat outer belt assembly on the RH side begins with checking the angle of retractor lock operation during gentle inclination from its initial position. The belt needs to remain unlocked up to 15 degrees while locking at 45 degrees or above. If locking or unlocking actions differ from the specifications, replace the rear seat outer belt. Install the retractor lower stay onto its corresponding pair of body hooks using a bolt which requires 41 Nm (420 kgf-cm, 30 ft-lbf) torque. After installing the through anchor with a bolt which requires 41 Nm (420 kgf-cm, 30 ft-lbf) torque check the ELR locks when pulling the belt out at swift speed. Replace the rear seat outer belt if this check fails. Proceed to install the roof side inner garnish assembly RH, the deck trim side panel assembly RH, the rear seat back hinge sub-assembly, the rear seat outer belt assembly RH, the luggage hold belt striker assembly, the rear deck trim cover, the rear door opening trim
Weather Strip RH, the rear door scuff plate RH, the rear seatback assembly RH, the rear seatback assembly LH, the rear seat cushion with cover pad sub-assembly, the deck floor box RH, the deck floor box LH, and finally the rear deck floor box.