OEM 2010 Toyota Camry Wiper Motor

2010 Toyota Camry Wiper Motor Parts Q&A

• Q: How to install the windshield wiper motor assembly and related components on 2010 Toyota Camry?

  A: The windshield wiper motor assembly installation requires securing bolts with 5.4 Nm (55 kgf-cm, 48 in-lbf) torque settings followed by proper position of crank arm movement and application of MP grease to the crank arm pivot point before attaching the No. 2 windshield wiper link rod to the assembly pivot. Install the No. 2 windshield wiper link rod onto the windshield wiper motor assembly pivot point. Begin by putting in place the windshield wiper motor with link assembly and fasten it with 4 bolts that need torquing to 7.5 Nm (77 kgf-cm, 66 in-lbf) with bolt attachment adherence to a specific order followed by connector connection. The cowl top ventilator louver sub-assembly requires installation with 4 claws before adding the 2 clips. Install the first front fender to cowl side seal RH with the claw mechanism then apply the same technique for the front fender to cowl side seal LH. The installation of the front wiper arm and blade assembly LH requires operating the wiper to stop the windshield wiper motor at automatic stop position while using a wire brush to clean serrations on the wiper arm and pivot before securing the assembly with a nut tightened to 20 Nm (204 kgf-cm, 15 ft-lbf) and fastened with hand pressure on the arm hinge. Functionality should be checked again by operating the front wipers when washer fluid is applied to the windshield glass while making sure the wipers avoid touching the car's body. This procedure should be performed on the right-hand assembly.