OEM 2010 Scion tC Fuel Injector

2010 Scion tC Fuel Injector Parts Q&A

• Q: How to remove the fuel injectors on 2010 Scion tC?

  A: The removal process for 2AZ-FE engine fuel injectors starts by following these steps: eliminate fuel system pressure through seat cushion removal, floor hole cover removal, fuel pump connector disconnection, engine idling until power stops then switch OFF along with removing the fuel cap. You should connect the fuel pump connector after which you need to install the rear floor service hole cover and rear seat cushion. Start by removing power from the negative terminal and after that take off the engine cover sub-assembly along with the air cleaner cap sub-assembly. The Special Service Tool: 09268-21010 helps cleanly disconnect the fuel tube through removing the fuel pipe clamp and cleaning the fuel tube connector before using the tool to release the tube from its position paper. After fuel drainage from the tube proceed by enveloping separated components with plastic material. To access the fuel delivery pipe sub-assembly disconnect the Number 2 ventilation hose from the ventilation valve and detach the 2 wire harness clamps before disconnecting the 4 fuel injector connectors while removing the 2 bolts to extract the fuel delivery pipe with all 4 fuel injectors without dropping any item. To complete the task remove the fuel delivery pipe spacers along with the insulators from the cylinder head while extracting the 4 fuel injectors from the pipe.