OEM 2009 Toyota Sienna Sway Bar Kit

2009 Toyota Sienna Parts Questions & Experts Answers

• Q: How to install the front Sway Bar Kit on 2009 Toyota Sienna?

  A: As the first step for installing the front sway bar kit on a 4WD system begin by placing the front sway bar kit and following it with the No. 1 front sway bar bushing with the slit facing toward the vehicle rear while the bushing sits on the outside of the sway bar bushing stopper. After installing the Exhaust manifold sub-assembly RH, you should add the manifold stay and steering intermediate shaft assembly. Finally install the rack & pinion power steering gear assembly while connecting the pressure feed tube assembly through the use of Special Service Tool: 09023-12701. Synchronize installation of the tie rod assembly LH with the tie rod assembly RH following the same procedures from the LH side. Install the front sway bar bracket No. 1 LH with two bolts that reach 17 Nm (173 kgf-cm, 12 ft-lbf) torque values before installing the front sway bar bracket No. 1 RH by repeating this approach. The center exhaust pipe assembly must install next with front sway bar link assembly LH then the RH side through identical installation steps. To complete the front wheel installation you must examine the center steering wheel point along with the front wheel axis alignment and test for power steering fluid leakage and bleed the power steering system before checking its fluid level.