OEM 2009 Toyota Sienna Rack And Pinion

2009 Toyota Sienna Parts Questions & Experts Answers

• Q: How to remove and replace the rack and pinion power steering gear on 2009 Toyota Sienna?

  A: Start the rack and pinion power steering rack and pinion replacement by checking the center front wheel and following it with front wheel removal. The technician should utilize Special Service Tool: 09628-62011 to disconnect first the left and then the right tie rod assembly while maintaining equal attention for both sides. Start the steering intermediate shaft assembly separation process by fixing the steering wheel to the seat belt while releasing three springs to detach the dust cover. The next step includes marking matched points on both assemblies before unbolt this intermediate shaft assembly from the power steering rack and pinion assembly. A similar process should be followed to separate the front stabilizer link assembly on both left and right sides of the vehicle. The left and right front stabilizer bracket No. 1 requires removal of its 2 bolts followed by repeating the same steps for the opposite side. The disconnect process for pressure feed tubes begins by removing the clip while unfastening the return tube assembly from the power steering rack and pinion assembly followed by tube clamp separation with Special Service Tool: 09023-12701 then completing the process by taking out the bolt and nut. Remove the rack and pinion power steering rack and pinion assembly after unscrewing both bolts and nuts with the careful prevention of any damage to the 2 pressure tubes.