OEM 2009 Toyota Sienna Drive Shaft

2009 Toyota Sienna Parts Questions & Experts Answers

• Q: How to remove the DRIVE SHAFT on 2009 Toyota Sienna?

  A: You must uninstall the exhaust pipe assembly before accessing the MF2A PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD). Press down on the brake pedal before maintaining a hold on it. A hexagon wrench (6 mm) should loosen cross groove joint set bolts one-quarter turn but users must put a cloth in the universal joint cover to stop boot contact. First mark both flanges and then remove all 4 nuts followed by bolts and washers and finally the 4 bolts, two adjusting shims and the propeller shaft with center bearing shaft assembly. Apply gentle force when extracting the universal joint while keeping the angling straight at less than 15 degrees to protect the oil seal from damage. The transfer extension housing requires Special Service Tool: 09325-20010(s) to block oil leakage while avoiding damaging the oil seal.