OEM 2009 Toyota RAV4 Yaw Sensor

2009 Toyota RAV4 Parts Questions & Experts Answers

• Q: How to install the Yaw Sensor assembly and complete the associated procedures on 2009 Toyota RAV4?

  A: Start the installation of the yaw rate sensor assembly by tightening two bolts to 15 Nm (148 kgf-cm, 11 ft-lbf) while making sure the sensor remains free of damage and gets properly fixed in place. Secure the yaw rate sensor through its connector. Fasten the yaw rate sensor bracket through a single bolt that receives 15 Nm (148 kgf-cm, 11 ft-lbf) torque value. Start the installation process by placing the front door scuff plate LH in position and afterwards install the front seat assembly LH on the same side. Manual seats should be installed as per procedure while power seats require following specific installation guidelines. Attach the cable wiring to the negative battery connection point when seats are properly installed. Complete the zero point calibration of the yaw rate and deceleration sensor followed by checking the yaw rate sensor signal for correct functionality.