OEM 2008 Toyota Matrix Oil Filter

2008 Toyota Matrix Parts Questions & Experts Answers

• Q: How to replace the oil filter on 2008 Toyota Matrix?

  A: The replacement process for the 1ZZ-FE engine oil filter begins with engine under cover removal on its right-hand side. Siphon all engine oil through the removal of the oil filler cap and oil drain plug while guiding it into an open container. Install the drain plug along with a new gasket by tightening it to 37 Nm (377 kgf-cm, 27 ft-lbf). The next step involves the removal of the oil filter sub-assembly using Special Service Tool: 09228-06501. Apply clean engine oil to the new filter gasket after checking and cleaning its installation area. When sufficient space is available you should apply Special Service Tool: 09228-06501 to achieve a torque of 13 Nm (133 kgf-cm, 10 ft-lbf); otherwise use hand tightening until the filter reaches a 3/4 turn. The filter installation process should be followed by filling the engine with new oil before putting the oil filler cap back in place. After leak inspection complete the right-hand side engine under cover reinstallation. Environmental protection requires disposing used oil and oil filters at proper waste sites while wearing protective clothing and gloves to prevent skin contact with used engine oil and following the skin wash procedures.