OEM 2008 Toyota 4Runner Blower Motor

2008 Toyota 4Runner Blower Motor Parts Q&A

• Q: How to install a blower motor and its related components on 2008 Toyota 4Runner?

  A: Begin the blower assembly installation by fixing the claw fitting first then add the bolt and two screws with the nut whereby the bolt torque should be set to 9.8 Nm (100 kgf-cm, 87 in-lbf) while the nut torque should be at 5.4 Nm (55 kgf-cm, 48 in-lbf). The installation of all 7 clamps should be followed by connector connection. Install Air Duct No. 2 and then proceed with Instrument Panel Register Assembly No. 2 and Instrument Panel Finish Panel Lower No. 2 before finishing the process with the Glove Compartment Door Sub-Assembly. The installation process for the glove compartment door should be followed by the instrument panel under cover sub-assembly and cowl side trim board RH together with the console box assembly rear. Afterward install console upper panel garnish no. 2, console upper panel garnish no. 1, and console panel sub-assembly upper until the console upper rear panel sub-assembly completes the assembly process.