OEM 2007 Toyota Sienna Wheel Stud

2007 Toyota Sienna Parts Questions & Experts Answers

• Q: How to service and repair the rear Wheel Stud on 2007 Toyota Sienna?

  A: Service and repair of the rear wheel stud starts with taking off the rear wheel. The process for servicing the rear disc brake caliper assembly LH requires separation for vehicles with both 2WD and 4WD equipped with disk rear brakes. Vehicle owners must detach rear brake drums as a necessary step when the rear brakes use drum mechanisms. The process begins with installing two nuts and washers to the rear axle LH wheel stud. Special Service Tool: 09628-10011(s) requires usage with a hammer handle or equivalent to remove the rear axle LH wheel stud. You should install a washer together with a nut onto the new rear axle LH wheel stud before tightening it with the help of a hammer handle or equivalent to maintain the hub & bearing assembly. Reinstall the rear disc brake disc for disk rear brake cars followed by the rear disk brake caliper assembly LH for both two-wheel drive and four-wheel drive vehicles. The last step involves installing the rear brake drum sub-assembly together with the rear wheel after tightening the components to 103 Nm (1,050 kgf-cm, 76 ft. lbs.).