OEM 2006 Toyota Tundra ABS Control Module

2006 Toyota Tundra Parts Questions & Experts Answers

• Q: How to service and repair the ABS Control Module for Antilock Brakes on 2006 Toyota Tundra?

  A: Start the service procedure of Hydraulic Control Assembly Antilock Brakes by first verifying that the ignition is off and pushing the brake pedal more than 20 times to release accumulator power supply system pressure while extending the stroke length and reducing reaction force weight. Follow the procedure by extracting liquid using a syringe and avoid allowing brake fluid to stay on vehicle paint while working. First disconnect and remove the front door scuff plate plus cowl side trim board, side panel, lower finish panel and No.2 heater to register duct. Unplug the two actuator connectors as well as the fluid level warning switch connector from its terminal. Using Special Service Tool: 09023-00101 disconnect the four brake lines letting the brake lines require correct reinstallation and demanding 15.2 Nm (155 kgf-cm, 11.2 ft. lbs.) torque during installation. To remove the hydraulic brake booster assembly begin by unscrewing the four booster installation nuts to 14.2 Nm torque then extract both the assembly and its gasket. The installation process begins by performing the opposite steps of removal while adding brake fluid into the reservoir before bleeding the brake system to check for any fluid leakage.