OEM 2006 Toyota Sequoia Wiper Motor

2006 Toyota Sequoia Parts Questions & Experts Answers

• Q: How to service and repair the rear wiper motor on 2006 Toyota Sequoia?

  A: Start service and repairs on the rear wiper motor by disassembling the rear wiper arm assembly through its cover opening and removing the nut and arm (torque at 5.5 N.m) and extracting the rear wiper motor grommet. Start by preparing a screwdriver with tape before using it to remove the wiper step liner. The process for back door pull strap removal starts by dismantling the strap cover then unscrewing the screw and finally removing the strap. Next follow the process by taking out the back door center garnish and side garnish using a screwdriver whose tip should be taped for protection. You should carefully loosen the back door trim board with a screwdriver while maintaining both products intact before removing the back door service hole covers from their right and left positions. After opening the back door glass to reveal the bolts present within the service hole users must disconnect the connector then consecutively remove the two bolts and guide bracket and finally the four bolts that keep the back door glass in place being careful to prevent accidental drops. The power window regulator assembly removal process starts with disconnecting the connector after which the assembly can be taken out by unclamping and disconnecting the connector while also removing the four nuts. The process to remove the rear wiper motor includes disconnecting the connector then disengaging the clamp and service hole plug before unfastening three bolts to extract the motor from its place. Remove the washer nozzle sub-assembly through the use of a screwdriver before disconnecting the washer hose. Installation begins with assembling the washer nozzle sub-assembly before proceeding to install the rear wiper motor while torquing the three bolts to 5.5 N.m and connecting the connector and clamp. Fasten the back door power window regulator assembly with a torque of 5.5 N.m and complete the installation by adding the back door glass with 8.0 N.m torque then attaching both back door service hole covers. Begin by putting on the back door trim board followed by side garnish and center garnish along with pull strap installation. Start by installing the wiper step liner and rear wiper arm assembly with minimal torque of 5.5 N.m applied to the nut when the wiper arm stands in a rise-up position. Also install the rear wiper motor grommet and operate the wiper once, switch off the wiper and torque the wiper arm nut to 5.5 N.m. The initialization process for the back door power window control system requires completing after unhooking the negative battery cable.