OEM 2005 Toyota Tacoma Wheel Stud

2005 Toyota Tacoma Parts Questions & Experts Answers

• Q: How to replace a Wheel Stud on the Front Axle on 2005 Toyota Tacoma?

  A: The first steps for Front Wheel Stud replacement involve disconnecting the negative battery terminal cable then taking off the front wheel. Stop the brake fluid flow while washing off all fluid touch points from painted surfaces immediately. According to procedure you must start by using Special Service Tool: 09023-00101 to take off the Front Disc Brake Caliper Assy LH before removing the front disc. When replacing the Front Wheel Stud achieve this task using Special Service Tool: 09611-12010 and a screwdriver. After inserting a new wheel stud through the axle hub, users should pass the washer plate through the bolt and tighten the hub nut. Reinstall the front disc and the Front Disc Brake Caliper Assy LH through use of Special Service Tool: 09023-00101. Attach the battery cable to the negative terminal while tightening it to 3.9 Nm (40 kgf-cm, 35 inch lbs.). The braking system needs new brake fluid input, and the bleaching process follows for both VSC and non-VSC situations through the master cylinder and brake line routes. The reservoir should be checked for proper fluid level during this process while also investigating any brake fluid leaking. Reinstall the front wheel by tightening it to 113 Nm (1,152 kgf-cm, 83 ft. lbs.).