Other Name: Cover Assembly, Timing Chain Or Belt; Engine Timing Cover; Front Cover; Cover Sub-Assembly, Timing Chain Or Belt
Part Name Code: 11302
Item Weight: 6.80 Pounds
Item Dimensions: 12.7 x 9.9 x 2.7 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 11310-0H010
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2005 Toyota Solara Submodels:
SE, SLE | 4 Cyl 2.4 L GAS
2005 Toyota Solara Timing Cover
Looking for affordable OEM 2005 Toyota Solara Timing Cover? Explore our comprehensive catalogue of genuine 2005 Toyota Solara Timing Cover. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2005 Toyota Solara Parts Questions & Experts Answers
Q: How to replace the timing cover or timing chain case oil seal on 2005 Toyota Solara?
A: Before performing the replacement on the timing gear case or timing chain case oil seal you need to take out 3 bolts from the front wheel RH, front fender apron seal RH, engine cover sub-assembly No.1 and engine moving control rod with bracket. Engine mounting stay No.2 RH and engine mounting bracket No.2 RH must be taken out next before removing both the fan and generator V belt. Start by using Special Service Tool: 09960-10010 (09962-01000, 09963-01000) to loosen the pulley bolt but finish removal with Special Service Tool: 09950-40011 (09951-04010, 09952-04010, 09953-04030, 09954-04010, 09955-04041, 09957-04010, 91111-51014). You can remove the timing gear case or timing chain case oil seal with the help of Special Service Tool: 09308-10010 and 09950-60010 (09951-00200). Install new oil seals by applying MP grease to their lips keeping them clear from foreign contaminants then use Special Service Tool: 09223-22010 and strike the oil seal with a hammer until it reaches equal height with the rear oil seal retainer edge and remove all excess grease from the crankshaft. The crankshaft pulley installation requires using Special Service Tool: 09960-10010 (09962-01000, 09963-01000) to insert the pulley bolt while aligning the pulley key with the key groove and torquing to a tightness of 170 Nm (1,733 kgf-cm, 125 ft. lbs.). The procedure calls for mounting engine bracket No.2 RH with 52 Nm torque (531 kgf-cm, 38 ft. lbs.) and engine mounting stay No.2 RH with 64 Nm (653 kgf-cm, 47 ft. lbs.) torque while the engine moving control rod with bracket requires 3 bolts torqued to 64 Nm (653 kgf-cm, 47 ft. lbs.). The procedure ends by fitting the front wheel right-hand side unit while inspecting for engine oil leakage.