Other Name: Sensor Assembly, Side Air Bag; Air Bag Impact Sensor, Front Right; Air Bag Sensor; Side Sensor; Sensor Assembly, Side Air Bag, Passenger Side
Position: Passenger Side
Part Name Code: 89860
Item Weight: 0.60 Pounds
Item Dimensions: 4.3 x 2.6 x 2.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89860-42020
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Sensor Assembly, Side Air Bag; Air Bag Impact Sensor, Front Left; Air Bag Sensor; Side Sensor; Sensor Assembly, Side Air Bag, Driver Side
Position: Driver Side
Part Name Code: 89860A
Item Weight: 0.60 Pounds
Item Dimensions: 4.4 x 2.6 x 2.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89830-42020
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2005 Toyota RAV4 Submodels:
Base, L, Sport | 4 Cyl 2.4 L GAS
2005 Toyota RAV4 Air Bag Sensor
Looking for affordable OEM 2005 Toyota RAV4 Air Bag Sensor? Explore our comprehensive catalogue of genuine 2005 Toyota RAV4 Air Bag Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2005 Toyota RAV4 Parts Questions & Experts Answers
Q: How to remove and install the side and curtain shield Air Bag sensor assembly on 2005 Toyota RAV4?
A: Start the removal of the side and curtain shield Air Bag sensor assembly by making sure the ignition switch shows an OFF position since the recording of DTCs will be avoided. The task starts by taking off the rear door scuff plate and front door scuff plate and center pillar lower garnish and front seat outer belt retractor. Detach the connector from the sensor assembly that stays in position before unscrewing the two bolts that fix the sidewall and curtain shield Air Bag sensor assembly. New parts must be used for all installation work while colliding sensors along with any attempt at repair constitute absolute installation prohibitions. The side and curtain shield Air Bag assembly must be installed with three bolts reaching 20 Nm (205 kgf-cm, 15 ft-lbf) torque while the connector must be connected after assembly installation. Check the sensor assembly for proper torque while looking for cracks or dents in its surface because damaged units need replacement. The SRS wiring installation should avoid obstructing other components while the sensor assembly must be exposed to shaking tests for loose connections. A proper installation requires starting with front seat outer belt retractor attachment by using 8.5 Nm (87 kgf-cm, 75 in.lbf) for the upper bolt while the lower bolt requires 42 Nm (430 kgf-cm, 31 ft-lbf). The sequence continues with center pillar lower garnish, front door scuff plate and rear door scuff plate installation.