Other Name: Sensor Assembly, Side Air Bag; Air Bag Impact Sensor, Front Right; Air Bag Sensor; Side Sensor; Sensor Assembly, Side Air Bag, Passenger Side
Position: Passenger Side
Part Name Code: 89860
Item Weight: 0.60 Pounds
Item Dimensions: 4.3 x 2.6 x 2.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89860-42020
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Other Name: Sensor Assembly, Side Air Bag; Air Bag Impact Sensor, Front Left; Air Bag Sensor; Side Sensor; Sensor Assembly, Side Air Bag, Driver Side
Position: Driver Side
Part Name Code: 89860A
Item Weight: 0.60 Pounds
Item Dimensions: 4.4 x 2.6 x 2.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89830-42020
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2004 Toyota RAV4 Submodels:
Base, L, Sport | 4 Cyl 2.4 L GAS
2004 Toyota RAV4 Air Bag Sensor
Looking for affordable OEM 2004 Toyota RAV4 Air Bag Sensor? Explore our comprehensive catalogue of genuine 2004 Toyota RAV4 Air Bag Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2004 Toyota RAV4 Parts Questions & Experts Answers
Q: How to remove and install the side and curtain shield Air Bag sensor assembly on 2004 Toyota RAV4?
A: One should begin by removing the rear door scuff plate followed by the front door scuff plate and center pillar lower garnish before taking out the retractor of the front seat outer belt. Unplug the connector before keeping the sensor assembly installed and then remove the two securing bolts from the sensor assembly. The installation process requires employment of new components and the permanent avoidance of employing sensors from debilitating crashes or implementing attempts to repair them. The side and curtain shield Air Bag assembly needs three bolts installation with 20 Nm (205 kgf-cm, 15 ft-lbf) torque values after the installation attach the connector and validate its specified torque values. The sensor assembly must be replaced by a new unit if drops occur or if you detect defects. Other components must not be affected by the SRS wiring which should remain free of pinching. A brief test through sensor assembly shaking should be conducted to verify proper installation. Set up the front seat outer belt retractor and limit the upper bolt torque to 8.5 Nm (87 kgf-cm, 75 in.lbf) as well as the lower bolt torque to 42 Nm (430 kgf-cm, 31 ft-lbf). The last steps involve replacing the center pillar lower garnish and both the front door scuff plate and rear door scuff plate.